Filter
Top Products
16
When controlling several projectors from each remote control at the same time, you can assign a remote
control code (Code 1 - Code 8) to individual projectors and remote controls to prevent remote control
interference. Assign the same code the you specified for the projector to the remote control. See “Remote
Control” on page 62 for assigning a remote control code to the projector. Follow the procedures below to select
the assigned code.
Remote Control Codes
Part Names and Functions
Press and hold the MENU and a number button (1–8)
for more than five seconds to switch between the
codes. To reset it to the default code number (Code 1),
use the button combination of the MENU button and
the 0 number button ( press for 5 seconds).
Number buttons
MENU button
✔Note:
To ensure safe operation, observe the following precautions:
• Do not bend, drop, or expose the remote control to moisture or
heat.
• For cleaning, use a soft dry cloth. Do not apply benzene, thinner,
spray, or any other chemical materials.