Filter
Top Products
76
Maintenance and Care
Check the LAMP 1/2/3/4 REPLACE indicators on top
of the projector. When any of the indicators blinks
rapidly, wait at least 20 minutes until it blinks slowly.
After that, go to the next step. When any of the
indicators blinks slowly, go to the next step.
Loosen the two screws that securing the lamp and
pull out the lamp by using the handle. (See the right
lower figure.)
Loosen the screw on the lamp cover. Open the lamp
cover. (See the right upper figure.)
Replace the lamp with a new one and tighten the
two screws. Make sure the lamp is set properly.
Follow these steps to replace the lamp.
Close the lamp cover and tighten the screw.
SCREW
LAMP COVER
LAMP 2
LAMP 1
Lamp Replacement
- For continued safety, replace with a lamp assembly
of the same type.
- Do not drop the lamp assembly or touch a glass
bulb! The glass can shatter and may cause injury.
- When replacing the lamp, do it within 30 minutes after
opening the lamp cover.
- Do not insert hand in the empty lamp compartment after
the lamp is removed.
Allow the projector to cool for at least 20 minutes
before you open the lamp cover. The temperature
inside the projector becomes very hot.
CAUTION
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the
screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one after it has cooled down.
The timing when the LAMP REPLACE indicator lights up is depending on the mode that you specified for the Lamp
control function.
LAMP REPLACE indicator
LAMP REPLACE indicator
LAMP 3
HANDLE
CAUTION
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be broken.
If replacing a lamp of the projector which has been installed on the ceiling, you should always assume that the
lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the lamp cover
gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get into your eyes or
mouth, seek medical advice immediately.
CAUTION
LAMP 4
LAMP 1/2/3/4 REPLACE indicators
Lamp replacement icon
SCREW
SCREW
1
2
3
4
5
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER.
WARNING: