Filter
Top Products
82
WARNING:
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the projector
or the service center. Specify the model number and explain about the problem. We will advise you how to obtain
service.
Appendix
The shutter does not
work.
– Check “Protection” or “Release Key” of the shutter function. (See page 66)
The power is turned off
automatically.
– Power management function runs by initial setting. Check “SETTING” section on page
63.
– When the filter replacement icon keeps appearing on the screen at turning on the
projector for some time and no action is taken to replace the filter, the projector will
be automatically shut down in 3 minutes after turning on to protect the projector. (See
pages 68, 88)
– Do not cover the ventilation slots on the projector. (See pages 4, 6)
– Projector may be used in high ambient temperature environment. Make sure the
temperature is not out of Operating Temperature (41˚F–104˚F [5˚C–40˚C]). (See page 92)
You cannot operate with
the side control.
– The side control is not available If the side control is locked at “Key lock” under
“Security” of SETTING section. Please check “SETTING” section on page 64.
The Remote Control does
not work.
– Check the batteries.
– Check if the RC sensor is set properly. (See page 63)
– Make sure no obstruction is between the projector and remote control.
– Make sure you are not too far from the projector when using the remote control.
Maximum operating range is 16.4’ (5m).
– Make sure that the remote control code conforms to the projector’s code.
(See page 62.)
– Check if the ON/ OFF switch on the remote control is set to ON.
– Unlock the Key lock function for the remote control. (See page 64)
– Wireless remote control does not work when the remote control cable is connected to
the projector. (See page 15)
Indicators blink or light.
– Check the status of the projector with referring to “ INDICATORS AND PROJECTOR
CONDITION” on pages 86-88.
appears on the screen
– Your operation is invalid. Operate correctly.
Unable to unlock the Logo
PIN code lock, Security
key lock or Security PIN
code lock.
– Contact the dealer where you purchased the projector or the service center.
Forget the Logo PIN code
or Security PIN code.
– Contact the dealer where you purchased the projector or the service center.
When brightness (Current
value) continuously
goes down to a certain
rate from Target value in
Constant mode.
– Check the lamp status and replace the lamp, or decrease Target value in Constant
mode.