Sanyo PLC-XU84 Projector User Manual


 
15
Part Names and Functions
Adjustable Feet
To insure safe operation, please observe the following precautions :
Use two (2) AAA or LR03 type alkaline batteries.
Always replace batteries in sets.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not expose the remote control to moisture or heat.
Do not drop the remote control.
If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
Risk of an explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Press the lid
downward and slide it.
Open the battery
compartment lid.
Install new batteries
into the compartment.
Replace the
compartment lid.
Two AAA size
batteries
For correct polarity (+
and –), be sure battery
terminals are in contact
with pins in
compartment.
12 3
Point the remote control toward the projector (Infrared
Remote Receiver) when pressing the buttons. Maximum
operating range for the remote control is about 16.4’ (5 m)
and 60 degrees in front of the projector.
Remote Control Operating Range
Remote Control Battery Installation
Projection angle can be adjusted up to 10.0 degrees with the
adjustable feet.
Lift the front of the projector and pull the feet lock latches
on both side of the projector upward.
Release the feet lock latches to lock the adjustable feet and
rotate the adjustable feet to a proper height, and tilt.
Keystone distortion can be adjusted automatically with the
Auto setup function or manually by using the remote control
or the menu operation (see pages 26, 45, 46).
Adjustable Feet
Feet Lock Latches
16.4’
(5 m)
60°
Remote control