Filter
Top Products
63
Appendix
Some displays are not seen – Check the Display function. See page 46.
during the operation.
PIN code dialog box appears – PIN code lock is being set. Enter a PIN code (the “1234” or numbers
at start-up. you have set). See pages 21, 52–53.
Computer 2 cannot be selected. – Select Computer 2 at the Terminal function. (See page 49.)
The Terminal function cannot – The Terminal function cannot be selected after Computer 2 is
be selected. selected. Select other input source such as Computer 1 or
Video with the INPUT button on the top control, the
COMPUTER button or the VIDEO button on the remote
control so that the Terminal function can be selected.
The Remote Control does – Check the batteries.
not work. – Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4’ (5 m).
– Make sure the code of the remote control is conformed to the
projector’s code. See page 51.
– Unlock the Key lock function for the remote control function. See
page 52.
– Check RESET/ON/ALL-OFF switch on the remote control is set to
“ON”. See page 12.
This symbol on the nameplate means the product
is Listed by Underwriters Laboratories Inc. It is
designed and manufactured to meet rigid U.L.
safety standards against risk of fire, casualty and
electrical hazards.
The CE Mark is a Directive
conformity mark of the European
Community (EC).
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the
projector or the service center. Specify the model number and explain about the problem. We will advise you
how to obtain service.
Pixelworks ICs used.