Sanyo PLC-XU84 Projector User Manual


 
TO MAINTAIN THE LIFE OF THE LAMP, ONCE
YOU TURN THE PROJECTOR ON, WAIT AT
LEAST FIVE MINUTES BEFORE TURNING IT OFF.
“Power off?” disappears after 4 seconds.
Tu r ning Off the Projector
Press the POWER ON-OFF button on the top control or
on the remote control, and “Power off?” appears on the
screen.
Press the POWER ON-OFF button again to turn off the
projector. The POWER indicator starts to blink red, and
the cooling fans keep running. (You can select the level
of fans’ quietness and speed. See “Fan” on page 54.)
At this time, you can unplug the AC power cord even if
the fans are still running.
1
2
3
When the projector has cooled down enough, the
POWER indicator stops blinking and you can turn on
the projector. After it is cooled down completely,
unplug the AC power cord.
Notes:
•When the On start function is set to “On,” the projector will be
turned on automatically by connecting the AC power cord to an AC
outlet (p.51).
•Do not operate the projector continuously without rest. Continuous
use may result in shortening the lamp life. Turn off the projector
and let stand for about an hour in every 24 hours.
The running speed of cooling fans is changed according to the
temperature inside the projector.
•Do not put the projector in a case before the projector is cooled
enough.
If the WARNING indicator blinks or lights red, see “Warning
Indicators” on page 56.
•While the POWER indicator is blinking, the lamp is being cooled
down and the projector cannot be turned on. Wait until the
POWER indicator stops blinking to turn on the projector again.
22
Basic Operation