Filter
Top Products
When the projection lamp of the projector reaches its end of
life, the Lamp replacement icon appears on the screen and
LAMP REPLACE indicator lights yellow. Replace the lamp with
a new one promptly. The timing when the LAMP REPLACE
indicator should light is depending on the lamp mode.
Follow these steps to replace the lamp.
ORDER REPLA
CEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
●
Model No. of your projector : PLC-XU87, PLC-XU84
● Replacement Lamp Type No. : POA-LMP106
(Service Parts No. 610 332 3855)
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
Allow a projector to cool for at least 45 minutes
before you open the Lamp cover. The inside of
the projector can become very hot.
CAUTION
Turn off the projector and unplug the AC power cord.
Let the projector cool for at least 45 minutes.
Remove the two (2) screws that secure the lamp. Lift
the lamp out of the projector by using the handle.
1
3
Replace the lamp with a new one and secure the two
(2) screws. Make sure that the lamp is set properly.
Close the lamp cover.
4
Remove the screw with a screwdriver, and remove
the lamp cover.
2
Connect the AC power cord to the projector and turn
on the projector.
6
Reset the lamp counter.
See “Resetting the Lamp Counter” on the next page.
5
Lamp Replacement
CAUTION
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
Top Control
Lamp replacement icon
58
Maintenance and Cleaning
Lamp
Screw
Handle
Screw
Screw
Lamp Cover
ON -
OFF
POWER
AUTO SET UP
INPUT
WARNING
LAMP REPLACE
MENU
SELECT
LAMP REPLACE
indicator