Filter
Top Products
52
This projector provides two different remote control
codes: the factory-set initial code (Code 1) and the
secondary code (Code 2). This switching function
prevents remote control interference when operating
several projectors or video equipment at the same time.
When operating the projector in Code 2, both the
projector and the remote control must be switched to
Code 2.
Select either Code 1 or Code 2 in this Setting Menu.
Press and hold both the MENU and IMAGE buttons
together for 5 seconds or more. After changing the code,
make sure the remote control operates properly.
• When different codes are set on the projector
and on the remote control, any operation
cannot be made. In that case, switch the
code on the remote control to fit the code on
the projector.
• If the batteries are removed from the remote
control for a long period of time, the remote
control code will be reset.
Setting
This function allows you to change brightness of the
screen.
Lamp control
• Lamp mode can not be changed for a while
after turning on the projector. Lamp needs
some time to stabilize after the power is
turned on. Stored lamp mode will be active
after the lamp is stabilized.
High ........... Brighter than the Normal mode.
Normal ....... Normal brightness
Eco ............ Lower brightness reduces the lamp
power consumption and extends the
lamp life.