Filter
Top Products
6
Openings in the cabinet are provided for ventilation. To
ensure reliable operation of the product and to protect it
from overheating, these openings must not be blocked
or covered.
Hot air is exhausted from the exhaust vent. When using
or installing the projector, the following precautions
should be taken.
– Do not put any flammable object or spray can near
the projector, hot air is exhausted from the ventilation
holes.
– Keep the exhaust vent at least 3’ (1 m) away from
any objects.
– Do not touch a peripheral part of the exhaust vent,
especially screws and metallic parts. These areas will
become hot while the projector is being used.
– Do not put anything on the cabinet. Objects put on the
cabinet will not only get damaged but also may cause
fire hazard by heat.
– Make sure that there is no object under the projector
to prevent from covering the bottom openings.
Cooling fans are provided to cool down the projector.
The fans’ running speed is changed according to the
temperature inside the projector.
When moving the projector, retract the adjustable foot
to prevent damage to the cabinet and use a suitable
carrying case.
When this projector is not in use for an extended
period, put it into a suitable case to protect the
projector.
Exhaust Vent
(Hot air exhaust)
Do not tilt the projector more than 30
degrees from above and below.
Do not point the projector up to
project an image.
Do not point the projector down to
project an image.
Do not put the projector on either side
to project an image.
Install the projector properly. Improper installation may
reduce the lamp life and cause a fire hazard.
Position
Do not tilt the projector more than 20
degrees from side to side.
20°
20°
30°
30°
– Do not drop or bump the projector, otherwise damages
or malfunctions may result.
– When carrying the projector, use a suitable carrying
case.
– Do not transport the projector by courier or any other
transport service in an unsuitable transport case. This
may cause damage to the projector. For information
about transporting the projector by courier or any other
transport service, consult your dealer.
– Do not put the projector in a case before the projector is
cooled enough.
Air Intake Vent
Air Intake Vent
(Filter)