Filter
Top Products
Unit 4: Printer Configuration
S8400 Series Operator Manual
4-34 PN: 9001160B
Allows the establishment of a specific distance the media will be advanced and retracted in
addition to distance set by the OFFSET potentiometer on the operator panel. If using thermal
transfer for printing, set the feed distance less than 30mm to avoid detection of the ribbon end by
accident.
Allows selection of output mode options. MODE1 outputs signal in the status of existence/non-
existence for the number of remaining labels to be printed. MODE2 outputs signal in the status of
online/offline.
Allows the printer to use either a NORMAL or FAST web acceleration. Large, heavy label rolls
should use the NORMAL option while smaller, lighter rolls can use the FAST option.
Allows the hexadecimal code to be specified for the character replaced with the Euro Character.
The default is D5H.
Allows the user to assign a method of command priority. Where programming instructions
conflict, the printer will allow this assignment to take priority. This priority assignment affects the
settings for print darkness, print speed, start position correction, operation mode, print method,
and sensor types.
Select the ENABLE option to set the printer to automatically notify when ribbon supply is nearly
exhausted.
Select ENABLE to allow the printer to redetect label pitch after the printer has been turned on
after having the print head open. When DISABLE is selected, label pitch will not be redetect and
the label must be manually positioned.
Allows the assignment of a function to the Function key. The NONE setting disables the button. It
may also be assigned the REPRINT command or to enter the SEMBL mode.
Permits the determination of whether a password will be required to access and change principle
configuration features.
Permits the assignment of a password. Use the vertical arrow keys of the operator panel to scroll
digit options and the horizontal arrow keys to move from one digit location to another. Press the
Enter key to record the four-digit password chosen.
Determines whether or not the printer will be compatible with a previous printer model. When the
Compatibility Mode is ON, the functions and settings that are unique to the printer will be disabled
or modified to match the characteristics of older printer models of the same family. This allows
legacy or custom-programmed labeling software to run on this printer without requiring
modification.
SERVICE MODE (TABLE 4-9)
MENU DESCRIPTION
FORWARD / BACKFEED
DISTANCE
DEFAULT XXX MM
EXT 9PIN SELECT
MODE1 MODE2
WEB ACCELERATION
FAST NORMAL
EURO CODE
XX
PRIORITY SETTING
COMMAND INTERNAL
RIBBON NEAR END
ENABLE DISABLE
LABEL RE-DETECT
ENABLE DISABLE
FUNCTION KEY
NONE
REPRINT
SEMBL
SET PASSWORD
ON OFF
PASSWORD NO.
XXXX
COMPATIBLE MODE
ON OFF