Filter
Top Products
Copying
18
2
Copying from the Bypass Tray
Use the bypass tray to copy onto OHP
transparencies, adhesive labels, translu-
cent paper, postcards and copy paper
that cannot be loaded in the paper trays.
Preparation
When the duplex unit is attached,
the default is [1 Sided→2 Sided].
When copying from the bypass
tray, select [1 Sided] for copying in
[Dup./Combine/Series] (for example
[1 Sided→1 Sided] or [2 Sided→1 Sid-
ed] ). You can change the initial set-
tings. See p.92 “Duplex Mode
Priority” .
Important
r When paper larger than 433 mm in
size is used, the paper may become
wrinkled, may not be fed into the
machine, or may cause paper jams.
Note
r If you do not use the standard size
copy paper or if you use special pa-
per, you should input vertical and
horizontal dimensions. See p.14
“Placing custom size originals”.
The sizes that you can input are as
follows:
*1
The range is 148–432 mm (5.8"–17")
when the booklet finisher is in-
stalled.
r The machine can automatically de-
tect the following sizes as standard
size copy paper:
r When copying on OHP transpar-
encies or paper heavier than 128
g/m
2
(about 34 lb.), you need to
specify the paper type. See p.20
“When copying onto special pa-
per” .
r The maximum number of sheets
you can load at the same time de-
pends on paper type. The maxi-
mum number of sheets should not
exceed the upper limit.
A Open the bypass tray.
B Insert the paper with the side you
want to copy facing down until
you hear the beep, and then align
the paper guide to the paper size.
1. Extender
Metric
version
• Vertical: 100–297 mm
• Horizontal: 148–600 mm
*1
Inch
version
• Vertical: 3.9"–11.6"
• Horizontal: 5.8"–23.4”
*1
Metric
version
A3L, A4KL, A5KL, 8
1
/
2
"
× 13"L
Inch
version
A3L, 11" × 17"L, 8
1
/
2
" ×
11"KL, 5
1
/
2
" × 8
1
/
2
"L
ZDSH110J
ZDSH100J