Filter
Top Products
TSX FPC 10 ISA card
51
Configuration of the operating system using the TSX FPC 10 card
At a Glance After the driver installation and configuration phase, the operating system shall
recognize the ISA TSX FPC 10 card and its driver.
Installation
principles
As this card is not automatically recognized by the operating system, the following
phases must be carried out:
Step Action
1 Select the hardware type:
for Win 98 see How to select the hardware type for Windows 98, p. 52,
for Win 2000/XP see How to select the hardware type for Windows 2000\XP,
p. 55,
for Win NT no operation is required.
2 Configure the parameters of the operating system to recognize the card:
for Win 98 see How to configure hardware parameters for Windows 98,
p. 58,
for Win 2000/XP see How to configure hardware parameters for Windows
2000\XP, p. 60,
for Win NT no operation is required.
3 Switch off the PC.
4 Adjust the card parameters (See How to adjust the ISA TSX FPC 10 card
parameters, p. 63):
the standard I/O address,
the IRQ interrupt address.
5 Connect the card to the ISA bus.
6 Turn the PC back on.
Result: the driver is operational.