Filter
Top Products
22
Installing an optional bezel
Use the following procedure to attach an optional bezel to the drive. The bezel
is available as an accessory (see section 4).
1. Remove the backing from the double-sticky tape attached to the rear surface
of the bezel.
2. Orient the drive and bezel as shown in Figure 9.
3. Align the mounting bosses on the rear of the bezel to the matching holes
in the drive chassis.
4. Press the bezel into place on the drive chassis ensuring that the mounting
bosses extend through the chassis holes and that the double-sticky tape
is in contact with both the bezel and chassis.
5. Remove the LED (if present) from the LED socket and insert the LED plug
from the bezel into the socket.