Filter
Top Products
24
Mounting the drive
The drive may be secured to the enclosure via tapped holes in either the sides
or the bottom of the drive chassis. Figure 10 shows two of the three allowable
orientations.
Note. The mounting screws must be completely engaged in the drive
chassis, but the portion that extends into the chassis must not exceed
3.2 mm (0.125 in) in length.
1. Place the drive into position in the enclosure and secure with four screws as
shown in Figure 10.
• For bottom mounting, use 6-32 screws.
• For side mounting, use either 6-32 screws or M4 X .70 (metric) screws.
There are tapped holes for each type.
2. Connect the 9-pin connector of the DC power cable to the output connector
on the power supply. Connect the 4-pin connector of the same cable to the
DC power connector J15 on the drive.
3. Connect the AC power cord to site power.