Filter
Top Products
Maintenance 41
Removing and replacing a power supply
To remove a power supply for maintenance, perform the following steps:
1. Remove power from the drive by setting the On/Standby switch on the power
supply to the Standby position.
2. Disconnect the AC power cable from site power.
3. Disconnect the DC power cable from the DC power connector on the power
supply.
4. Remove the chassis safety ground screw from the power supply to
disconnect the ground strap.
5. Remove the mounting screws that secure the power supply to the cabinet.
6. Carefully lift the power supply from its mounting, and move it to the desired
location.
To install a replacement power supply, follow the procedures in section 2.
Packing a drive for shipment
If it is necessary to ship the drive, repack the drive with the original packing
materials (saved during installation). Comply with the packing instructions to
ensure that the drive will be undamaged in shipment. To obtain packing
instructions or a new shipping container, contact:
Seagate Technology, Inc.
Customer Services
7801 Computer Avenue South
Minneapolis, MN 55435
Phone: 1-800-382-6060(outside Minnesota)
Phone: (612) 844-8080 (inside Minnesota)
Fax: (612) 844-7017
When ordering packing instructions or a new shipping container, specify the
exact equipment number and series code of the drive as shown on the
equipment identification label.