Seagate ST43400N/ND Computer Drive User Manual


 
38
Table 8 below lists the part numbers for options and accessories for system
installation.
Table 8. Options and accessories
Part
Number Description
12263496 Static ground wrist strap, 6 1/2 to 8 inch wrist
** I/O cables
** External terminators
96752447 Terminator resistor-pak, single-ended
15479501 Terminator resistor-pak, differential
47188890 Power supply (with internal cooling fan)
75168323 AC power cord set, 100–120 V, 60 Hz, 5-15P
75168334 AC power cord set, 208–240 V, 60 Hz, 6-15P
75168324 AC power cord set, 208–240 V, 50 Hz
89500420 DC power cable, 24 inches (609.6 mm) long (power supply to drive)
89500422 DC power cable, 6 inches (15.2 cm) long (power supply to drive)
70553701 Bezel, black (with red LED, cable, and double-sticky tape)
70553702 Bezel, black (with green LED, cable, and double-sticky tape)
70703929 Spindle sync cable*, 1.5 foot (0.46 meter) long
70703921 Spindle sync cable*, 3 foot (0.92 meter) long
70703922 Spindle sync cable*, 5 foot (1.52 meter) long
70703923 Spindle sync cable*, 7 foot (2.12 meter) long
70703924 Spindle sync cable*, 10 foot (3.05 meter) long
70703925 Spindle sync cable*, 20 foot (6.10 meter) long
70703926 Spindle sync cable*, 30 foot (9.14 meter) long
70703927 Spindle sync cable*, 40 foot (12.20 meter) long
70703928 Spindle sync cable*, 50 foot (15.24 meter) long
70574221 Spindle sync terminator
97630051 Shunt, two-pin (2 mm) (Used to select options on circuit board
jumpers J4A and J4B)
* A custom cable may be needed for spindle sync connection between a drive and
an external source.
** See the reference manual (publication 83327640) for part numbers of terminators,
complete I/O cables, and connectors and cabling needed to create custom I/O
cables.