Filter
Top Products
10. CONTROL PANEL
Before starting to work, ensure that the Power SW is off. Failure to observe this
can cause an electric shock or short circuit.
Be careful not to change wirings. Damaged wiring can cause electric shock or
short circuit.
Do not touch undesignated places. Touching places not designated can cause
electric shock or short circuit.
This work should be performed by the location’s Maintenance man or service
man. Performing work by non-technical personnel can cause an electric shock
hazzard.
Do not perform work other than what is specified in this Manual in order to
prevent accidents during performing work and operation after performing
work. Performing work not specified in this manual may require special train-
ing for this product. If you perform work other than what is stated in this
manual that is required for repair, contact the offices stated in the manual or
where you purchased the product. Ask for repair or inquire how to repair.
Use caution when handling the parts inside the control panel. Be careful not
to damage, misplace, or deform any parts. Damaging small a portion of
a part can cause malfunctioning.
When securing the plastic-made parts, do not excessively fasten screws and nuts.
Failure to observe this may damage the parts and cause injury due to fragments
resulting from damage.
In this product the input units are mounted on the control panel. The input units include the
left and right levers on the control panel, the Brake Lever (the right-hand side), the BOOST
button( the center), the START button (the lower right), and the SELECT buttons beside the
START button on the control panel. Be sure to check the reaction of each input unit on a
monthly basis. If the operability is poor and performing CALIBRATION in test mode does
not improve the situation, the cause may be a malfunction of the input unit in the control
panel.
50