Open as PDF
Place the copier on a firm, level surface.
Do not install the copier in a humid or dusty location.
When the copier is not used for long time, for example for consecutive holidays,
turn the power switch off and remove the power cord from the outlet.
When moving the copier, be sure to turn the power switch off and remove the
power cord from the outlet.
Do not cover the copier with a dust cover, cloth or plastic film while the power
is on. Doing so may prevent heat radiation, damaging the copier.
Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
This Digital Copier is rated Class 1 and complies with 21 CFR 1040.10 and 1040.11 of
the CDRH standards. This means that the copier does not produce hazardous laser
radiation. For your safety, observe the precautions below.
Do not remove the cabinet, operation panel or any other covers.
The copier’s exterior covers contain several safety interlock switches. Do not bypass
any safety interlock by inserting wedges or other items into switch slots.
High-speed laser copying
Since warm-up time is zero, copying can be started immediately after the power switch
is turned on.
First-copy time is only 9.6 seconds (normal mode).
Copying speed is 15 copies/min., which adapts to business use, allowing improvement
of working efficiency.
High-quality digital image
High-quality image copying at 600 dpi can be performed.
In addition to the automatic exposure mode, the manual exposure can be adjusted in
The photo mode copying function allows clear copying of delicate halftone original images
such as monochrome photos and color photos.