Filter
Top Products
1-6
CHAPTER
1
GETTING STARTED Power on and off
Auto power shut-off mode
If the auto power shut-off mode is enabled, the copier will
automatically turn off the power once a programmed length of time
has elapsed without any copier operation after the last copy of a run
is made or the power is first turned on. The power switch will
automatically be turned to the “OFF” position.
To turn the power back on, simply turn the power switch to the “ON”
position.
★ KEY OPERATOR See page 21 of the KEY OPERATOR’S GUIDE for
setting the auto power shut-off timer. See page 27 of the KEY
OPERATOR’S GUIDE for enabling or disabling the auto power shut-off
mode.
Preheat mode
The copier will enter the mode once the set time has elapsed without
any copier operation after the last copy of a run is made or power is
turned on.
When the copier enters the preheat mode, the message “PREHEAT
MODE. PLACE ORIGINALS.” will appear.
In this condition, the fuser in the copier is maintained at a lower heat
level thereby saving power. The preheat level is, however, high
enough to allow the copier to come to a ready condition or begin
copying approximately 30 seconds after any key input is made.
To copy from the preheat mode, make desired copier selections and
press the START key using the normal copying procedure.
★ KEY OPERATOR See page 22 of the KEY OPERATOR’S GUIDE for
information on setting the preheat mode.
As an ENERGY STAR
®
Partner,
SHARP has determined that this
product meets the ENERGY
STAR
®
guidelines for energy
efficiency.
POWER ON AND OFF