Filter
Top Products
2-18
CHAPTER2
JOB MEMORY
Frequently used job programs can be stored in one of nine storage
registers. This is convenient for quick job recall without losing time
manually reprogramming each aspect of the job.
●
All functions that can be set in the copy mode except the copy
quantity setting can be stored in the job memory.
●
If any function which has been stored in a job program is modified
by a key operator program, the key operator settings will supercede
the previous setting.
★ KEY OPERATOR Job memory replacement/deletion can be
prohibited. See page 25 of the KEY OPERATOR’S GUIDE.
Storing a job program
1
Press the PROGRAM key.
●
The JOB PROGRAMS screen will appear on the touch panel.
2
Press the “STORE/DELETE” key on the touch panel.
●
To cancel the job memory mode, press the “EXIT” key or the
CLEAR ALL (
CA
) key.
3
Select a program number from 1 to 9 on the touch panel.
●
The numbers which are highlighted are program numbers which
have been used.
●
If a program number which has been used is entered, a message
will appear to confirm the selection. To replace with the new
program, press the “STORE” key and proceed to the next step.
To cancel replacement, press the “CANCEL” key.
4
Make all copier selections to be stored.
5
Press the “OK” key to complete the storage.
MAKING COPIES Job memory
8
9
0
C
CLEAR
PROGRAM
LEAR
P
STORE/DELETE
RECALL
JOB PROGRAMS
STORE/DELETE
RECALL
PRESS PROGRAM NUMBER.
EXIT
MAKE COPIER SELECTIONS AND PRESS
[OK].
OK
CANCEL
AUTO
EXPOSURE PAPER SELECT
100%
COPY RATIO
AUTO 8/ 11
1
2
1.8/ 11
2.11 17
1
2