Filter
Top Products
E-20
Basic Operation of the Projector
1
2
Projector
ON/OFF
Remote control
ON/OFF
POWER
LAMP
TEMP.
When the power is on, the LAMP
REPLACEMENT indicator flashes
to show the operating condition of
the lamp.
Green: Lamp is ready
Flashing green: Warming up
Red: Change bulb
ON
OFF
3
E-ZOOM (ON)
4
E-ZOOM (OFF)
When the MAIN
POWER is on, the
POWER indicator
lights red.
POWER
LAMP
TEMP.
ONOFF
ONOFF
1 AC cord
1. Connect the AC cord
Open the socket cover and connect the supplied AC cord
to the socket.
2. Turn on the MAIN POWER
Turn the MAIN POWER switch on the side of the projec-
tor. The POWER indicator lights red and the projector
enters STANDBY mode.
3. Turn on the POWER
Press the POWER ON/OFF button on the projector or the
POWER ON button of the remote control.
• When the power is turned off by pressing the POWER
ON/OFF button, the POWER indicator will not turn off
until the fan has stopped running.
• See page 31, “Lamp/Maintenance Indicators” for
details.
Notes:
• When the POWER indicator is not lit, the remote control
cannot be used to operate the projector.
• If the power is turned on immediately after it has been turned
off, it may take a short while before the lamp turns on. (During
this period the LAMP REPLACEMENT indicator flashes.)
• After the projector is unpacked and turned on for the first time,
a slight odor may be emitted from the exhaust fan. This odor
will soon disappear with use.
4. E-ZOOM Function
This projector has an E-ZOOM mode which enlarges the
display when inputting an image of less than 800 × 600
dots in size. The E-ZOOM button of the remote control is
used to operate E-ZOOM function.
See page 26, “E-ZOOM Function” for details.
Notes:
• E-ZOOM function does not operate with monochrome images
or in SVGA (800 × 600), Mac 16" (832 × 624), NTSC, PAL or
SECAM INPUT mode.
• The picture size differs in RGB, NTSC, PAL and SECAM
INPUT modes.
2 MAIN POWER switch