Filter
Top Products
E-71
Maintenance &
Troubleshooting
This function can be used to set the lamp mode.
The mode can be set to double the effective lamp usage
time.
Description of Lamp Mode
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select “Options (2)”.
3 Press ∂/ƒ to select “Lamp Mode”, and then
press ©.
4 Press ∂/ƒ to select the desired Lamp Mode.
5 Press ENTER to save the setting.
6 To exit from the GUI, press MENU.
• In “Equal Use” mode, when the projector is used for more than
24 hrs. continuously, it switches in shift of 100 hrs.
Setting the Lamp Mode
1.2.3 4.5.6
1, 6
5
2, 3, 4
Remote ControlProjector
(GUI) On-screen Display
Selected item
Both Lamps
Lamp 1 Only
Lamp 2 Only
Equal Use
Description
Both lamps are used for greater brightness.
Lamp 1 is used.
When lamp 1 burns out, automatically
switches to lamp 2.
Lamp 2 is used.
When lamp 2 burns out, automatically
switches to lamp 1.
Both lamps are used alternatingly.
Switches after every 100 hrs. of use.
Replacing the Lamp
It is recommended that the lamp be replaced after approximately 900 cumulative hours of use or when you notice
a significant deterioration of the picture and color quality. Carefully change the lamp by following the steps on the
next page.
If the new lamp does not light after replacement, take your projector to the nearest Authorized Sharp Industrial
LCD Products Dealer or Service Center for repair. Purchase a replacement lamp unit (lamp/cage module) of the
current type BQC-XGV10WU/1 from your nearest Authorized Sharp Industrial LCD Products Dealer or Service
Center. Then carefully change the lamp by following the instructions on the next page. If you wish, you may have
the lamp replaced at your nearest Authorized Sharp Industrial LCD Products Dealer or Service Center.
IMPORTANT NOTE TO U.S. CUSTOMERS:
The lamp included with this projector is backed by a 90-day parts and labor limited warranty. All service of this
projector under warranty, including lamp replacement, must be obtained through an Authorized Sharp Industrial LCD
Products Dealer or Service Center. For the name of the nearest Authorized Sharp Industrial LCD Products Dealer or
Service Center, please call toll-free: 1-888-GO-SHARP (1-888-467-4277).
U.S.A. ONLY
CAUTION
• Potential hazard of glass particles if lamp ruptures. In case of lamp rupture, contact your nearest
Authorized Sharp Industrial LCD Products Dealer or Service Center for a replacement.
• Do not remove the lamp cage directly after operation of the projector. The lamp may be extremely
hot. Wait at least one hour after the power cord is disconnected to allow the surface of the lamp cage
to fully cool before removing the lamp cage.
MOUSE
ADJ.