Filter
Top Products
-18
Setting Up the Projector
Projecting a Reversed Image
Projection from behind the Screen
■ Place a translucent screen between the projector and the audience.
■ Reverse the image by setting “Rear” in the “PRJ Mode” menu. (See page 52.)
Projection Using a Mirror
■ Place a mirror (normal flat type) in front of the lens.
■ When the translucent screen is placed between the mirror and audience, set to “Front” in the “PRJ Mode”
menu. (See page 52.)
■ When the mirror is placed on the audience side, set to “Rear” in the “PRJ Mode” menu. (See page 52.)
Info
•When using a mirror, ensure to carefully position both the projector and the mirror so the light does not
shine into the eyes of the audience.
Ceiling-mount Setup
■ It is recommended that you use the optional Sharp ceiling-mount
bracket for this installation.
■ Before mounting the projector, contact your nearest Sharp Au-
thorized Service Center or Dealer to obtain the recommended
ceiling-mount bracket (commercially available). (AN-CM270 ceil-
ing-mount bracket, AN-EP101B extension tube for AN-CM270.)
■ Invert the image by setting “Ceiling + Front” in “PRJ Mode”. See
page 52 for use of this function.
Translucent screen
Audience
Set to “Front”
Audience
Tr anslucent screen
Mirror
Set to “Rear”
Audience
Mirror
DT400_E_P16_18.p65 04.10.18, 1:17 PM18