Filter
Top Products
11
English
Connecting the monitor and turning
the monitor on and off
Connecting the monitor to a power source
Use only the AC adapter and power cord supplied.
Notes:
• Do not overly bend the cable or add extension cords
as this could lead to malfunction.
• Do not remove the label next to the power-input
terminal. Also do not touch the switch covered by the
label.
1. Remove the rear cover.
4. Connect the AC adapter to the monitor’s power
terminal, and connect the power cord to the AC
adapter.
2. Remove the stand cover.
As in the diagram below, place two fingers on the
stand cover and while pushing the ▼ section 1, pull it
forwards 2.
3. Remove the adapter cover.
While pushing the ▼ section 3, pull it forwards and
off 4.
5. Place the AC adapter inside the stand.
Wind the AC adapter cable and place it in the right-
hand end of the stand 5.
Place the AC adapter inside 67. When doing this be
careful not to place the AC adapter on top of the
cable as this will make it difficult to replace the
adapter cover.
Run the AC adapter cable between the AC adapter
and the stand 8.
6. Replace the adapter cover.
Rear cover
2
1
1
1
2
Stand cover
4
3
Adapter cover
7. Replace the stand cover.
9
0
Run the analog signal
cable through here.
Run the AC adapter
cord through here.
Run the power cord through here.
8
5
7
6
Note: Take care not to
bend or twist the cord
CAUTION!
Be careful not
to cut or jam
your fingers.
Run cord
through hole
AC adapter
Power cord