Filter
Top Products
30
Instructions for installing a VESA compliant arm
An arm based on the VESA standard can be attached to
the monitor. The arm must be purchased separately.
When choosing the arm to be installed please take note
of the following points.
• The arm should be compatible with the VESA
standard, and there must be a gap of 75mm x 75mm
between the screw holes on the section to be
attached.
• The arm must not fall off or break off after being
attached to the monitor.
Information
The stand is specially made for use with this
monitor. Once having removed the stand, never
attempt to attach it to another device.
Once having removed the screws, store them
together with the stand and if the stand is ever re-
attached be sure to use the original screws.
Using different screws could lead to malfunction.
Information
The screws used to
attach the arm should be
M4 screws with a length
of 4 mm ~ 6 mm
protruding from the
surface to be attached.
Using different screws
could lead to malfunction
or may lead to the
monitor falling off,
internal damaged,
personal injury.
4 ~ 6 mm
Screw used to
attach arm
Arm
Part of monitor
to which arm is
attached
5. Remove the four screws and then remove the stand
from the monitor.
6. Attach the rear cover.
To attach it follow step 8 of Connecting the monitor
to a power source on page 12.
7. Attach the arm to the monitor with four screws.
CAUTION!
Be careful not to cut or jam your fingers.
Note:
• Do not bend the signal cable or the AC adapter cable
nor place weight on them. Doing so could lead to
damage.
1. Turn off the power switch and remove the power plug
from the power source.
2. Remove the rear cover, stand cover and adapter
cover.
To remove them follow steps 1, 2, and 3 of
Connecting the monitor to a power source on
page 12.
3. Remove the AC adapter from the stand.
4. Being careful not to damage the monitor, spread out
a soft cloth and lay the monitor on it display-side
down.