Filter
Top Products
12
8. Replace the rear cover.
Connecting the monitor and turning the monitor on and off
If connecting to a D-sub 15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter (to be
purchased separately) to the analog signal cable.
Macintosh conversion
adapter
Analog signal cable
After connecting the adapter, tighten the
screws on each side to fix into place
w
q
9. Place power plug into AC outlet.
Connecting the monitor to a computer
(PC etc.)
For analog RGB output terminal
Connecting to a computer with analog RGB output.
When connecting, ensure that both the monitor and
computer are switched off.
Notes:
• If using the monitor for the first time or after having
changed the system settings during use, perform an
automatic screen adjustment (p. 19).
• Be careful not to overly bend the cable or add
extension cords as this could lead to malfunction.
• When connecting to a notebook, if the notebook
computer's screen is set so that it is displaying at the
same time, the MS-DOS screen may not be able to
display properly. In this case, change the settings so
that only the monitor is displaying.
Computer
Analog signal cable
Note:
If connecting to the Sun Ultra series, a conversion
adapter (purchased separately) may be required.
For digital RGB output terminal
Connecting to a computer with digital RGB output.
When connecting, ensure that both the monitor and
computer are switched off.
Notes:
• A computer with an output terminal conforming to DVI
(DVI-D24 pin or DVI-I29 pin) and with SXGA output
capability can be connected here. Depending on the
type of computer to be connected, the display may
not work correctly. In order to connect, it is necessary
to purchase a digital signal cable separately. (model
name: NL-C01E)
• Be careful not to overly bend the cable or add
extension cords as this could lead to malfunction.
1. Remove the rear cover and the stand cover.
To remove them follow steps 1 and 2 of Connecting
the monitor to a power source on page 11.
2. Attach the digital signal cable (sold separately from
monitor).
Digital signal input terminal (DVI-D24 pin)
Firmly insert the plug then tighten the screws
each side.
Run cable through hole
Digital signal
cable
Analog signal
cable
Analog RGB output terminal (mini D-sub 15 pin
with 3 rows)
Firmly insert the plug then tighten the screws
each side.
If you are not using the analog signal cable, you can
remove it. Loosen all screws on the plug and
disconnect it.