Silex technology SX-200 Printer User Manual


 
User’s Guide
Document #40182-420 Rev. A
48
Parallel Port Commands
SH PORT
Shows Port parameters
sample output:
Port Q-Size Type Attributes
*P1 0 parallel BID ACKH NBUF
SET PORT
Sets Parameters for specified port. The available commands are dependent on the port type.
For EasyLAN Wireless Model AW02, the only port available is parallel port P1.
SET PORT P1 ACKH
Enable or disable pACK handshake (1284 compatible) mode. ECP and Fast Strobe mode must be disabled for
compatibility mode to be used.
SET PORT P1 ACKH [ENABLE | DISABLE]
(default = enable)
SET PORT P1 BIDir
Enable or disable bidirectional mode
SET PORT P1 BIDir [ENable | DIsable]
(default = enable)
SET PORT P1 ECP
Enable or disable 1284 ECP mode. If enabled, this mode takes priority over compatibility (ACKH) and fast strobe
(FSTB) mode.
SET PORT P1 ECP [ENable | DIsable]
(default = enable)
SET PORT P1 FSTB
Enable or disable fast strobe mode. This mode handshake only with the busy line from the printer. If enabled, this
mode take priority over the compatibility (ACKH) mode of operation.
SET PORT P1 FSTB [ENable | DIsable]
(default = disable)
SET PORT P1 INWT