Silex technology SX-200 Printer User Manual


 
User’s Guide
Document #40182-420 Rev. A
74
WPA Auto Associate
If the WPA Auto Associate mode is enabled, then if there are no WPA enabled access points available
with the given SSID, the unit will attempt to associate with a non-WPA access point with the given SSID, if
available. The authentication mode will still have to match. For WPA-EAP, the non-WPA AP will have to
be configured for EAP authentication, and for WPA-PSK mode, the non-WPA AP will have to be in open
system mode. The default is disabled.
WPA Group Key
If the WPA Group Key mode is enabled, then group keys may be used for data link encryption.
The default is disabled.
--------------------------------------------------------------------------------
Command Line Console Configuration
Go to the command prompt on your PC and type TELNET ipaddress (where ipaddress is the IP Address
configured in the print server). You should get a # prompt, type in the password (default is ACCESS, this
will not echo on your screen as you type it). Hit Enter a couple times until you get a Local> prompt. This is
where you can type your commands. Type HELP to get a list of commands.
The following console commands can be used to configure your network security settings:
SH NW
Displays summary network information
sample output:
WiFi Mode = INFRASTRUCTURE
WiFi SSID: silex
Speed = 11
Regulatory Domain = 704
WiFi FW Ver = 1F 1.7.1
AP density = LOW
TTLS is Disabled
WEP is Disabled
Link DOWN
SET NW AUTHtype
Sets WLAN Authentication type
SET NW AUTHtype [OPEN |SHARED | TLS | TTLS | LEAP | PEAP | PSK]
(default = Open System)
SH NW AUTH
Shows the wireless authentication type
sample output:
Authentication type= OPEN SYSTEM
SET NW CHannel
Sets WLAN ad-hoc channel number