Filter
Top Products
User’s Guide
Document #40182-420 Rev. A
79
Sets the password used for the 802.1x EAP authentication, if enabled.
SET NW PW <password>
(default = anonymous)
SET NW INAP
Sets EAP Inner-Authentication protocol
SET NW INAP [PAP|MSCHAP_V2]
(default = PAP)
SH NW INAP
Shows the selected inner authentication mode
sample output:
Authentication protocol = PAP
Note: the deprecated command SH NW TTAP will also return this information.
SET NW REALM
Sets the realm portion of the 802.1x EAP authentication ID This may also be set with the ID command.
SET NW REALM <realm>
(default = <null>)
SH NW REALM
Shows the realm associated with the authentication ID, if any.
sample output:
somewhere
Note: The default realm is a null (blank) string
Note: The deprecated command SH NW TTRE will also return this information.
SET NW WPAAUTO
Enable or disable WPA/WPA2 auto mode. If enabled, the print server will connect to a non-WPA access
point if a WPA enabled access point is not available. Only valid when WPA is enabled (authentication
type = TKIP).
SET NW WPAAUTO [ENable | DIsable]
(default = disabled)
SH NW WPAAUTO
Shows the state of the WPA/WPA2 auto connect flag
sample output:
WPA-AUTO Enabled
SET NW WPAGROUP