Silex technology SX-200 Printer User Manual


 
User’s Guide
Document #40182-420 Rev. A
60
Enable or disable the TFTP protocol
SET IP TFTP [ENable | DIsable ]
(default = enable)
SET IP TImeout
Set TCP Inactivity timeout , in seconds if fast timeout is enabled, otherwise in minutes.
SET IP TImeout n
(default = 1 minute)
SET IP WIndow
Set TCP maximum window size in bytes
SET IP WIndow nn
(default = 10240)
SH IP
Shows TCP/IP related Parameters
sample output:
IP is enabled
IP address 192.0.0.192 Boot tries 3
Subnet mask 0.0.0.0 Boot method AUTO
IP Gateway 0.0.0.0 Max window 10240
(set manually)
LPD banner disabled Timeout 1 min
LPD retries are disabled Keepalive 5 min
Service Port TCP port
xxxxxx_S1_A S1 9100
xxxxxx_S1_B S1 3001
Power Configuration Commands
SET POWER DELAY nnnn
This is the time, in milliseconds, to wait before the processor goes into power save mode. If no I/O occurs on the
network or from the attached peripheral within this time period, the processor will go into low power mode. The
value must be between 0 and 1800000 (30 minutes). A value of 0 disables processor power saving. The default value
is 0.
SET POWER PERIOD nnnn
If radio power save is enabled, this the time, in milliseconds, between radio wake up events. The value must be
between 1 and 65535. The default value is 65535.
SET POWER WINDOW nnnn