Filter
Top Products
61
8
Chapter 8
8
Problems related to general use of the machine, the copy function, and software
setup are explained here. Be sure to check the problem carefully before calling for
service, as many problems can be solved by the user.
If you are unable to solve the problem, turn off the main switch, unplug the power
cord from the outlet, and contact your dealer.
DISPLAY MESSAGES
When the following indicators light up or blink on the operation panel or the following
alphanumeric codes appear in the display, solve the problem immediately referring
to both the table below and the indicated page.
For problems related to the printer and scanner functions, see the
online manual.
Be sure to use only genuine SHARP parts and supplies.
Indication
Cause and remedy Page
Lamp indicator Display
Tray
location
indicator
Blinks
BYPASS : ADD
PAPER
The indicated paper tray is not
attached, is attached incorrectly, or has
run out of paper. (The tray is indicated
in <*>.)
15
TRAY<*> : ADD
PAPER
CLOSE PAPER
TRAY<*>
Error
indicator
Blinks
CLEAR PAPER JAM.
A paper misfeed has occurred.
Remove the misfeed as explained in
"MISFEED REMOVAL".
70
SPF/RSPF JAM.
FRONT OR SIDE
COVER OPEN.
CLOSE COVERS.
The cover is open. Close the cover. -
CLOSE THE SPF/
RSPF COVER.
The RSPF cover is open. Close the
RSPF cover.
-
REPLACE THE
TONER CARTRIDGE.
The toner cartridge is empty. Replace
the toner cartridge with a new cartridge.
74
SYSTEM ERROR
[XX - XX] REFER
TO USER GUIDE
When [L1-00] appears, the scan head
locking switch is locked. Turn off the
power, release the scan head locking
switch, and turn the power back on.
76
When [F2-02] appears, check the toner
cartridge and make sure that the seal
is not still affixed.
-
The machine will not function. Turn the
power switch off, wait about 10 seconds,
and then turn on the switch again. If this
does not clear the error, remove the
power cord from the outlet, and contact
your SHARP service center.
-
Note
Note
TROUBLESHOOTING AND
MAINTENANCE
!AR-208S_208D.book 61 ページ ２００７年１２月３日 月曜日 午後３時３３分