Filter
Top Products
13
Preparations
Enabling the REC Command via a
Network for a Cassette with a
Memory Label
Execution of the REC command via a network when using
a cassette with a memory label attached is normally
disabled to prevent overwriting of a file that has been
already received.
However, you can execute the REC command via a
network for a cassette wtih a memory label in a case in
which no file has been created by any user.
1
Do steps 1 to 3 of “Basic Network Settings” (see page
9) to display the M5: NETWORK page of the
maintenance menu.
2
Rotate the MULTI CONTROL knob to bring the
cursor (*) to M57: OTHERS CONFIG, and then press
the F5 (SET) button to display the sub-page.
3
Rotate the MULTI CONTROL knob to bring the
cursor (*) to M571 REC WITH TELE-F, and then
press the F5 (SET) button.
The M571: REC WITH TELE-F setting page appears.
4
Rotate the MULTI CONTROL knob to change the
setting.
enable: If no file has been created, execution of the
REC command execution is enabled even if the
cassette inserted in the e-VTR has a memory label.
disable (default setting): REC command execution is
disabled for any cassette inserted in the e-VTR that
has a memory label.
5
Press the F5 (SET) button.
The message “Save Complete” appears.
Enabling File Creation Exceeding
the Capacity of a Memory Label
Creation of a file exceeding the capacity ot the memory
label attached to the cassette is normally disabled.
With the following menu operation, you can enable
continuous file creation even after the capacity of the
memory label is exceeded. Note that the files to be created
after the capacity of the memory label is exceeded will be
temporary files.
For the temporary files, see the description under “File
list” on page 25
1
Do steps 1 to 3 of “Basic Network Settings” (see page
9) to display the M5: NETWORK page of the
maintenance menu.
2
Rotate the MULTI CONTROL knob to bring the
cursor (*) to M57: OTHERS CONFIG, and then press
the F5 (SET) button to display the sub-page
3
Rotate the MULTI CONTROL knob to bring the
cursor (*) to M572: TEMP FILE CREATE, and then
press the F5 (SET) button.
OTHERS CONFIG
M570: REC WITHOUT TELE-F
M571: REC WITH TELE-F
M572: TEMP FILE CREATE
OTHERS CONFIG
M571: REC WITH TELE-F
enable
Push SET button