Filter
Top Products
. ..then press EXE (without releasing ENTER).
PAGE
5
Iam
DELAY
Channel 26 has been entered and presetting is
complete. The display returns to the reception
display.
To cancel presetting input
Release ENTER.
*To
change the
page
number and channel number
input, you can
also use the +/-keys when the number is flashing in the display
(i.e.;
while holding down ENTER).
*If the page number flashing in the display is already the one of
your choice when you hold down ENTER, you do not need to
press the page number again; press EXE to enter.
*After the page number has been entered, the receiver will first
display the number of the lowest unoccupied channel.
Therefore, when you are presetting stations the first time around
on a particular page, the receiver will automatically start from
channel number 1 and move up in order every time you preset a
station, without having to input the channel number manually.
Notes
*The
“10/0”
key functions as 10 for the page number, but as 0 for
anything else. To input page number
10,
press the
“10/0”
key. To
input channel number 10, press “1” and then
“10/0”.
*If there is no unoccupied preset channel on the page you have
chosen, “PRESET
-
-” will flash in the display.
*If you preset a frequency on a channel that already has a preset
frequency, the older frequency will be overwritten by the new
one.
l When you preset a frequency, the DELAY setting (see “Adjusting
scanning pause time”, page 30) for the particular frequency is
memorized as well.
To change the DELAY setting for a preset frequency, first recall
the preset frequency (see “Recalling a preset channel” below),
then press PRI/DELAY for one second or longer. The new
DELAY setting will be memorized along with the preset
frequency (DELAY will turn on if it had been off, vice versa).
*You cannot preset a station you have received with Memory
Scanning, whether or not the receiver is in scanning pause.
*You cannot preset a priority channel frequency you have
received with Priority Scanning.
Recalling a preset channel
1
Press POWER to turn the receiver on.
2
If you are in the Scanning Mode, press SCAN to enter
the Manual Mode.
m
will disappear from the display.
3
Press PAGE, then the number key for the page
number you wish to recall, then EXE.
4
Press PRESET, then the number key for the preset
channel number you wish to recall, then EXE.
23