Sony MKS-2015 Switch User Manual


 
160 Basic Settings
Chapter 9 System Settings
Use the arrow buttons to scroll the reverse video
cursor.
Turn the knobs to make the setting.
The selected source number appears in reverse video.
5
Press [Set] in the button area.
In the “Video” column of the “Video/Key Pair” list,
the selected source name changes to the source name
selected in step 4.
6
To set the key signal for the selected pair, press [Key
Assign] in the button area, setting it to “Enable.”
7
With the same operation as in step 4, select the source
number to be assigned as the key signal.
8
Press [Set] in the button area.
In the “Key” column of the “Video/Key Pair” list, the
selected source name changes to the source name
selected in step 5.
Saving Setup (Startup Mode Menu)
Using the Startup Mode menu, you save the setup state of
the devices constituting the switcher system and the initial
status after powering on in the nonvolatile memory of each
device.
Saving the setup state
1
From the top menu, select Setup/Diag >System
>Startup Mode.
The Startup Mode menu appears. The status area
shows the current settings (see page 154)
2
Press [Setup Define].
A confirmation message appears, prompting whether
or not to save the current setup state.
3
Press [Yes] in the dialog box.
This saves the state.
To cancel saving
Press [No] in the dialog box.
Saving the initial status
1
Carry out step 1 in the procedure “Saving the setup
state” (previous section).
2
Press [Init Define].
A confirmation message appears, prompting whether
or not to save the current state of the devices as the
initial status.
3
Press [Yes] in the dialog box.
This saves the state.
To cancel saving
Press [No] in the dialog box.
Knob Description Setting
values
4 (Source No) Source number selection 1 to 33