Filter
Top Products
8 (EN)
Control Panel
Location and Function of Controls
RESET
PATTERN PICTURE
AUDIO LIGHT
POWER
ENTER
MENU
INPUT
SELECT
MUTING VOLUME
POWER
STANDBY
LAMP
TEMP
u
1
2
3456789!…!`
1 POWER key
Press to turn the projector on and off once the
projector is in the standby mode. The POWER
indicator lights in green when the power is turned on.
When turning off the power, press and hold
the POWER key for about one second.
2 LIGHT key
Lights the back lighting (orange) for the control panel
when the power is turned on. Press again to turn off
the back lighting.
3 Indicators
POWER: Lights in green when the power is turned
on. Flashes in green while the cooling fan runs
after turning off the power with the POWER key.
The fan runs for about 1 minute and 30 seconds
after turning off the power. The POWER indicator
flashes quickly for the first minute. During this
time, you will not be able to turn the power back
on with the POWER key.
STANDBY: Lights in red when the MAIN POWER
switch at the rear of the projector is turned on.
Once in the standby mode, you can turn the
projector on and off with the POWER key on the
control panel or the Remote Commander.
Note
When the MAIN POWER switch is turned off,
there will be a slight delay before the indicator goes
off.
LAMP: Lights up or flashes under the following
conditions:
• Lights up when a trouble has prevented the lamp
from lighting.
• Flashes when the lamp cover or air filter cover is
not secured firmly.
Note
When the LAMP indicator lights up, never open the
lamp cover if the projector is installed on the
ceiling.
TEMP (Temperature): Lights up or flahes under
the following conditions:
• Lights up when temperature inside the projector
becomes unusually high.
• Flashes when the fan inside the projector stops.
For details on the LAMP and the TEMP indicators, see page
34.
4 INPUT SELECT key
Selects the input signal. Each time the key is pressed,
signal from equipment connected to VIDEO IN and
INPUT-A connectors is selected alternately.
5 MENU key
Press to display the on-screen menu. Press again to
clear the menu.
6 ENTER key
Press to enter the settings of items in the menu system.
7 Arrow keys (V/v/B /b)
Used to move the on-screen cursor or to make various
adjustments.
8 RESET key
Press to restore the value of an item back to its factory
preset value. This key functions when the menu or a
setting item is displayed on the screen.
9 VOLUME +/– keys
Adjust the volume of the built-in speakers and output
level of the AUDIO OUT connectors.
+ : Increases the volume.
– : Decreases the volume.
! º MUTING keys
Cuts off the picture and sound.
PICTURE: Press to cut off the picture. Press again to
restore the picture.
AUDIO: Press to cut off the sound. Press again or
press the VOLUME + key to restore the sound.
! ¡ PATTERN key
Display a pattern on the screen for focus adjustment.
Press again to clear the pattern.