Star Micronics NX-10 Printer User Manual


 
72
Table 5-4
International character set commands
I Countrv
The characters that change are shown beneath their ASCII
code in Table 5-5.
Table 5-5
International character sets
Country ~35~36~64~91~92~93~94~96~123~124~125~12
U.S.A I#lsl@lcl\lll*l’lcl:l,l~
IFrance
I Germany l#l$lsl~l~lul^l’l~lal~lR
al~lrl~lil~l~l~l~l~l-
England
f .I. G I.
Demark type I #$@E~L-zi;;-
Sweden
#rl~At5AUBZ~Bi.i
Italy
n Printing characters in the control code area
When you refer the Appendix B, you’ll find many characters
are printed in the control code area. (Remember that the low-
order control codes are the ASCII codes 0 through 31 plus 127,
and the high-order control codes are 128 through 159 plus 255.)
These codes don’t normally print symbols on paper, rather
they cause the printer to change modes. To make them print as
normal symbols requires an extra command. For example, the
-
-
-