Filter
Top Products
Instruction Manual
27
2. Click “Firmware”
3. Click “Get latest version”
4. Click http://18235253.net/......
5. Save the latest firmware file to your computer. It will
take a few minutes for downloading, depends on the
speed of your network.
6. Upload the latest firmware file from your computer to
the IPKVM. It will take more than 5 minutes for uploading
and writing it to the flash memory of the SV441DUSBI.
Auto Self Upgrade: The SV441DUSBI unit includes an
innovative feature allowing it to upgrade itself over the internet. Simply
click on the button labeled Upgrade to Latest and the unit will use the
internet to download the latest version of the system firmware and then
install it.
If it cannot access the Internet directly (perhaps due to a web proxy or
other firewalls), then a page will be shown that prompts your browser to
download the required file. Save this file to disk and then manually upload
it as described in the next section.
Purchase Options
Certain firmware features may be offered separately from the base unit, in
order to reduce the initial cost for the Server Remote Control unit.
NOTE: If you wish to upgrade after the system is in operation, go to the
Manage Firmware page and scroll down to the section entitled Purchase
Options. Look for a unique code, such as: 4-C80C-B960-1-0. If you
provide this code to the technical support department, they can give you
an unlock code that will open any feature you request. Type the provided
code into the area provided and click Submit. The new features opened
by the code will be enabled immediately, but you may need to reboot the
unit to begin using certain features.
Manual Upload: Enter the name of the firmware file that you downloaded
from StarTech.com into the field provided (or use the Browse... button).
Press Start Upload and wait until a successful upload message is shown.
NOTE: Remember the following during the firmware upgrade:
Do NOT turn off power to unit before this operation completes •