INSTALLING THE VTL VALUE APPLIANCE IN AN EQUIPMENT RACK
8 VTL Value Hardware Installation Guide • Aug 2007 A • 316196101
▼ Attaching the outer/middle rail assembly to the rack
1. Before you begin, push the middle rail into the corresponding outer rail so that the ends
are more or less flush. To do this, release the spring-activated slide-rail lock (
A below)
by pushing twice in the direction shown (
B), then telescope the middle rail into the outer
rail (
C):
2. Adjust the length of the middle/outer slide-rail assemblies to the distance between the
front and rear posts of the rack (
D above).
A
B
C
D