Filter
Top Products
INSTALLING THE VTL VALUE APPLIANCE IN AN EQUIPMENT RACK
316196101 • A Chapter 1 Installing VTL Value hardware 11
▼ Adjusting and securing middle/outer slide rails
1. Once both slide rails are loosely fastened at the front, insert the slide-rail spacing
tool/rack installation aid (
A below) into the outer rail brackets at the front of the rack
(
B).
2. Hold the slide-rail spacing tool in place as you tighten all four front screws with a #2
Phillips screwdriver (
C above).
The spacing tool should be a snug fit and might require pressure to ensure that it is fully
engaged with the left and right slide rails.
3. Pull the slide-rail spacing tool straight out from the slide rails, taking care not to
deform its alignment tabs.
A
B
C