Filter
Top Products
INSTALLING THE VTL VALUE APPLIANCE IN AN EQUIPMENT RACK
14 VTL Value Hardware Installation Guide • Aug 2007 A • 316196101
Caution – To reduce the risk of serious personal injury or equipment damage, use a
mechanical lift when mounting the server in the rack. If a lift is not available, remove
components as described in the section “Obtaining required tools, personnel, and materials”
on page 2 and following.
1. Pull the middle rails out from the outer rails, past the internal stop, so that the middle
rails are about 1.5 inches from the front face of the rail mounting bracket (
A below).
2. Make sure that the outer-rail ball-bearing retainer (
B above) is pulled to front of rail.
3. Make sure that the spring tab on the outer rail ball-bearing retainer is securely latched
over the dimple on the middle slide rail (
C above).
A
B
C
D