1-8 Sun Fire X2100 Server Getting Started Guide • April 2006
4. From the front of the rack, set the proper width of the rails with spacer. (See
FIGURE 1-5.)
FIGURE 1-5 Setting the Rail Width
5. Tighten the screws on the brackets.
6. Remove the spacer and confirm that the rails are attached tightly to the rack.
7. Repeat Step 4 through Step 6 for rear of the rack.
8. If available, extend the anti-tip foot at the bottom of the rack. (See FIGURE 1-6.)
Caution – If your rack does not have an anti-tip foot, there is some danger of the
rack tipping.