Filter
Top Products
28
PDT 8100 Series
with Intel XScale
Technology
During data com-
munication, no
data was trans-
mitted, or trans-
mitted data was
incomplete.
Terminal re-
moved from cra-
dle or unplugged
from host PC dur-
ing communica-
tions.
Replace the terminal in the cradle,
or replace the Synchronization ca-
ble, and re-transmit.
Incorrect cable
configuration.
See your System Administrator.
Communication
software was in-
correctly installed
or configured.
Perform setup as described in the
PDT 8100 Series with Intel XS-
cale
TM
Technology Product Refer-
ence Guide.
No sound is audi-
ble.
Volume setting is
low or turned off.
Check the System Volume slider in
the Sounds & Reminders proper-
ties dialog box (under Start/Set-
tings) to ensure the volume is not
turned down.
Terminal turns it-
self off.
Terminal is inac-
tive.
Your terminal turns off after a peri-
od of inactivity. If the terminal is
running on battery power, this peri-
od can be set from 1 to 5 minutes,
in one-minute intervals. If the ter-
minal is running on external power,
this period can be set to 1, 2, 5, 10,
15, and 30 minutes.
Check the Power dialog box (in the
System tab under Start/Settings),
and change the setting if you need
a longer delay before the automat-
ic shutoff feature activates.
Battery is deplet-
ed.
Replace the battery.
Battery cover is
removed.
Replace the battery door.
Problem Cause Solution