Filter
Top Products
D14637.01—MARCH 2010
18
TANDBERG Quick Set C20/C20 Plus and Profiles using C20
Administrator guide
Contents Introduction Advanced configuration Password protection About monitors Appendices Contact us
www.tandberg.com
Network [1..1] Speed
Set the ethernet link speed.
Valuespace: <Auto/10half/10full/100half/100full/1000full>
Auto: Autonegotiate link speed.
10half: Force link to 10Mbps half-duplex.
10full: Force link to 10Mbps full-duplex.
100half: Force link to 100Mbps half-duplex.
100full: Force link to 100Mbps full-duplex.
1000full: Force link to 1Gbps full-duplex.
Example: Network 1 Speed: Auto
Network [1..1] TrafficControl Mode
Configure how video packets transmission speed shall be controlled.
Valuespace: <On/Off>
On: Transmit video packets at maximum 20Mbps. Can be used to smooth out bursts in the outgoing
network traffic.
Off: Transmit video packets at link speed.
Example: Network 1 TrafcControl: On
NetworkServices Multiway Address
Set the Multiway address equal to the Conference Factory Alias, as set up on the VCS.
Multiway™ conferencing enables video endpoint users to introduce a 3rd party into an existing call. It can
be used in the following situations:
1) When you want to add someone else in to your existing call.
2) When you are called by a 3rd party while already in a call and you want to include that person in the call.
Requirements: The TANDBERG Codec C20 must be running TC3.0 (or later), TANDBERG VCS version
X5 (or later) and TANDBERG Codian MCU version 3.1 (or later). Endpoints invited to join the Multiway™
conference must support the H.323 routeToMC facility message if in an H.323 call, or SIP REFER message
if in a SIP call.
Valuespace: <S: 0, 255>
Format: String with a maximum of 255 characters.
Example: NetworkServices Multiway Address: “h323:multiway@company.com”
NetworkServices Multiway Protocol
Set the protocol to be used.
Valuespace: <Auto/H323/SIP>
Auto: The system will select the protocol for Multiway calls.
H323: The H323 protocol will be used for Multiway calls.
SIP: The SIP protocol will be used for Multiway calls.
Example: NetworkServices Multiway Protocol: Auto
NetworkServices H323 Mode
Determines whether the system should be able to place and receive H.323 calls.
NOTE! Changes in this setting requires the codec to be restarted.
Valuespace: <On/Off>
On: Set to On to enable the possibility to place and receive H.323 calls.This is the default setting.
Off: Set to Off to disable the possibility to place and receive H.323 calls.
Example: NetworkServices H323 Mode: On
The Network settings, cont... The Network Services settings
Contact us
Contents
Introduction
Advanced configuration
Password protection
About monitors
Appendices
Advanced config.