D14637.01—MARCH 2010
39
TANDBERG Quick Set C20/C20 Plus and Profiles using C20
Administrator guide
Contents Introduction Advanced configuration Password protection About monitors Appendices Contact us
www.tandberg.com
Pin: 19 17 3 1
Pin: 18 16 4 2
HDMI pin-out
External view of socket
DVI-I pin-out
External view of socket
RCA pin-out
External view of socket
GNDSignal
RJ-45 Connector pin-out
1 ---------- 1
2 ---------- 2
3 ---------- 3
6 ---------- 6
Wiring diagram
standard cable
TOP
FRONT
1 8
1 8
RS232 9 pin D-SUB pin-out
External view of socket
1 5
6 9
Pin-out schemes
This page gives an overview of the pin-out schemes for C20.
HDMI Pin-out
Pin Assignment Pin Assignment
1 T.M.D.S. Data 2+ 11 T.M.D.S. Clock Shield
2 T.M.D.S. Data 2 Shield 12 T.M.D.S. Clock–
3 T.M.D.S. Data 2 – 13 CEC
4 T.M.D.S. Data 1 14 Reserved (N.C. on device)
5 T.M.D.S. Data 1 Shield 15 SCL
6 T.M.D.S. Data 1 – 16 SDA
7 T.M.D.S. Data 0 17 DDC/CEC Ground
8 T.M.D.S. Data 0 Shield 18 +5 V Power (max 50 mA)
9 T.M.D.S. Data 0– 19 Hot Plug Detect
10 T.M.D.S. Clock+
Pin-out—TANDBERG camera cable
Signal name RJ-45 pin D-SUB pin
+12V DC 1 Twisted pair 4
GND 2 5
RX 3 Twisted pair 2
TX 6 3
NC 4 Twisted pair 1
NC 5 6
GND 7 Twisted pair 5
+12V DC 8 4
Pin-out—VISCA™ camera control
RJ11, 8 pins shielded modular jack
Pin Signal name
8 +12V (presence 2.8mA current source when
connected in daisy chain)
7 GND
6 TXD (out)
5 NC (no connect)
4 NC (no connect)
3 RXD (in)
2 GND
1 +12V
Codec C20 audio connectors
Jack Mic input RCA line input RCA line output
Connector pin out Tip = Hot
Ring 1 = Cold
Ring 2 = Mic. control
Shield = GND
Pin = Signal
Shield = GND
Pin = Signal
Shield = GND
Signal type Balanced Unbalanced Unbalanced
Connector (codec) Mini Jack 3.5mm Female RCA/phono Female RCA/phono
Input impedance 1.5k Ohm/leg 18k Ohm
Output impedance 100 Ohm
Maximum input level -18.3dBu +/-2dB 9.0dBu +/-2dB
Maximum output level 8.2dBu +/-2dB
Phantom power 12V +/-1V
Phantom power resistor pin ”tip” 1.7k Ohm
Phantom power resistor pin ”ring 1” 1.7k Ohm
Frequency response 20Hz-20kHz +/-1dB 20Hz-20kHz +/-1dB 20Hz-20kHz +/-1dB
Signal to Noise Ratio -85dB -95dB -95dB
Microphone, 3.5 mm Mini-Jack, 4 pole
Microphone control
Ground Audio– Hot
Audio– Cold
Contact us
Contents
Introduction
Advanced configuration
Password protection
About monitors
Appendices
Appendices