Filter
Top Products
TANDBERG MPS API
User Guide
55
*r/end
OK
DefaultValuesSet
Command used to reset configurations to default values.
Parameters:
• Level: <1..3> Configurations are divided into three different storage
classes. The level parameter denotes that configurations on this level
and all levels below are to be reset.
OK Result parameters:
None
ERROR Result parameters:
• Cause: <1…> Cause code specifying why the command was not
accepted by the system
• Description Textual description of the cause code.
Example:
xcommand defaultvaluesset level:2
*r Result (status=OK):
*r/end
OK
Dial
Command used to initiate an outgoing call.
Parameters:
• Conference(r): <1..35>
• Number: <S: 0, 60> Number to dial.
• SecondNumber: <S: 0, 60> 2Xh221 second number
• SubAddress: <S: 0, 60> Sub address
• CallRate:
<1xh221/2xh221/64/128/192/256/320/384/H0/512/768/1152/1472/15
36/1920/Tlph> Specifies the callrate to use
• Restrict: <On/Off>
• NetProfile: <1..7>
• NetworkId: <1..32>
• NetworkModule: <1..12>
• DTMFSend: <S: 0, 32>
OK Result parameters:
• CallRef: <1..96> Reference to the call. To be used as reference
when monitoring the call.
• LogTag: <1…> Unique reference to call. Identifies the call in the call
log.
ERROR Result parameters:
• Cause: <1…> Cause code specifying why the call was not accepted
by the system
• Description Textual description of the cause code.
Example:
xcommand dial number:666 callrate:256 netprofile:3
*r Result (status=OK):
CallRef: 26
LogTag: 312
*r/end