TANDBERG 6000 Computer Monitor User Manual


 
TANDBERG Videoconferencing System
45
General use
Web-interface
It is possible to access and maintain the system remotely via a local area network (LAN) using a standard Web-
browser.
Connect your system to a local area network.
Configure your codec:
Press MENU, select ‘Terminal Settings’, ‘LAN Settings
Specify IP-assignment ‘DHCP’ or ‘Static’. If DHCP is selected no other settings are needed. If Static is
selected, ‘IP-address’, ‘IP-subnet mask’ and ‘Gateway’ must be specified.
Example:
IP-assignment: Static
IP-address: 196.9.200.129
IP-subnet mask: 255.255.255.0
Gateway: 196.9.200.21
See ‘LAN Settings’ in ‘Advanced use’ for further information.
Start your Web-browser. In the address field type the IP-address of the codec. Enter the password and the
Web-page of the codec will be shown. The default password is ‘TANDBERG’.
THE SYSTEM MUST BE RESTARTED BEFORE CHANGES IN THE
‘LAN SETTINGSMENU CAN TAKE EFFECT.
NOTE
LAN
Text Chat / Closed Captioning
While in an ISDN or IP call to another system supporting Text Chat (T.140), select ‘Text Chat’ from the Web-page
of the codec. Enter text in the window displayed. When selecting ‘Send Text’, the text will be displayed on the
local and far-end monitor as shown below:
The local Text Chat window can be closed manually from the Web-interface by pressing ‘Close Window’. It will
also close automatically after a few minutes without activity.