Filter
Top Products
TANDBERG Videoconferencing System
53
Advanced use
Auto-PIP
On: Your selfview will automatically be displayed as a PIP (Picture-In-Picture) whenever the camera position
or video source is changed. Picking up the remote control will also display your selfview.
Welcome Menu
The Welcome menu can be shown when the system is not in use, and when sleep-mode is not activated.
On: The Welcome Menu is shown when the system is not in sleep mode.
Off: The Welcome Menu is not shown.
Logo: If a logo is uploaded to the system, it will be shown when this button is selected. See also Appendix 5.
Continuous Presence
On: The screen is divided into three or four squares, each displaying the video image of a different participant.
Off: The active site will be displayed in full screen during a MultiSite conference. Also called Voice Switched
mode.
MCU status line
On: The MultiSite/MCU/DuoVideo indicators will be displayed and provide information about the conference.
Off: The MultiSite/MCU/DuoVideo indicators will not be displayed.
Auto: The MultiSite/MCU/DuoVideo indicators will be displayed for a few seconds and then timed out. When
grabbing the remote control, the indicators will be shown again.
System Name
Identifies the system:
• during an MCU conference call.
• when using the Web-interface.
• when the codec is acting as an SNMP Agent.
• towards a DHCP server.
• as an H323 ID. Other systems can call in using this name instead of IP-number/IP-address.
TO DISPLAY YOUR SITE IN FULL SCREEN WHEN ‘ON’ IS SELECTED, PRESS THE QUICK KEY ‘REQUEST FLOOR’.
TIP