Filter
Top Products
07506C DCN6727 A-1
APPENDIX A Firmware
Commands
The firmware commands are divided into the categories
described below.
Commands Description
READ
Used to read parameters from the instrument
(such as flow rate, pressure, temperature, etc.).
READ commands can be identified by a
leading "R".
SET
Set an internal parameter to the value(s) supplied
with the command (supplied parameters are
always delimited by a comma). SET commands
can be identified by a leading "S". The instrument
will reply to all SET commands with the string
"OK"<CR>.
Note: When the instrument does not understand a command, it
replies with the string "ERROR".
Table A-1 is a quick reference of all the firmware commands.
Mor
e detailed information about each command can be found on
the following pages.
Note: The commands are not case sensitive.