Filter
Top Products
Teledyne API Ultrafine Particle Monitor - Model 651 Instrument Operation
07506C DCN6727 51
MASK
SETUP | NETWORK SETUP | MASK
Allows you to specify the network mask.
Note: The Mask must match the size of your network. A typical
setting is 255.255.255.0 for a small network.
To set the Mask, follow the instructions for using the onscreen
keypad to set the IP Address.
GATEWAY
SETUP | NETWORK SETUP | GATEWAY
Allows you to specify the network gateway device. To specify the
Gateway, follow the instructions for using the onscreen keypad to
set the IP Address.
ANALOG OUTPUT
SETUP | NETWORK SETUP | MORE | ADDITIONAL SETUP |
ANALOG OUTPUT
Allows you to set the function of the analog output. Press the
button to scroll through the options. Settings are 1.00, 100, 1000,
1.0 E
4
,
1.0 E
5
,
1.0 E
6
,
1.0 E
7
#/cm
3
FS, LOG OUTPUT (Logarithmic
output) and STATUS OUTPUT (where a normal Status Output is 0.
Abnormal output is 5V).
LOGGING
SETUP | NETWORK SETUP | MORE | ADDITIONAL SETUP | LOGGING
Allows you to choose intervals for logging data to the Flash Memory
Card. Logging options are either one hour, or one day. Press the
button to toggle between the options.
TOTAL Screen
Pressing the TOTAL button on the home screen takes you to the
TOTALIZER screen. The screen displays the following information:
Current particle concentration in #/cm
3
.
Number of accumulated particles.
Sample time in seconds.
Volume based on flow rate and sample time.
This option is useful for manually measuring concentration over a
period of time.
There is a toggle button at the bottom of the screen. When you
choose TOTAL from the Home screen, the toggle button displays
CLEAR TOTALIZER. When you press CLEAR TOTALIZER, the
button displays START TOTALIZER.