Filter
Top Products
Teledyne API Ultrafine Particle Monitor - Model 651 Unpacking and Setting Up the Model 651
07506C DCN6727 31
Figure 2-7
Installing Model 651 in a Rack
2. Place the Model 651 in the rack.
WARNING
When mounting the instrument in a rack location be certain that the
back panel power on/off switch is accessible or that a readily accessible
means of disconnecting power is provided.
Connecting the USB Cable
Connect the provided USB cable to the USB connector on the back
panel of the Model 651. If you have placed the monitor in a rack,
you can use an extension cord to connect the port at the back of
the instrument to the port on the rack-mount handle to give you
easy access to the USB port.
Connecting Power and Warming up the Model 651
After you connect the power, the warm-up process takes
approximately 20 minutes.
Follow these instructions to connect the power and warm up the
Model 651:
1. Plug the power cord provided with the Model 651 into the power
connector (100 to 240 VAC 50/60 Hz 175 W) on the back panel.
2. Plug the cord into an earth-grounded AC power source (100 to
240 VAC, 50 to 60 Hz, 175 W).